Stainless Steel Rear Fairing Bolt Kit with Hook Bolts and Washers for Honda CBR1100XX Blackbird

8x stainless steel rear fairing bolts and 4x stainless steel washers, including the listed hook bolts and 22 mm-head dimpled shoulder bolts. For the original mounting arrangement on the Honda CBR1100XX Blackbird 1997–2007.

Close OEM-style fit and appearance

The bolts match the corresponding original Honda fixing dimensions and head sizes. The two 90112-MAT-000 replacements retain the original 22 mm head diameter, shoulder dimensions, Allen-key fitting and dimpled head-face detail. Hook bolts and washers are supplied for the rear mounting positions shown in the contents table.

These are Biker Bling aftermarket replacements, not genuine Honda-branded parts. Honda references identify the original components being replaced.

What you receive

• 2x rear fairing shoulder bolts — replacement for 90112-MAT-000.
• 2x rear fairing bolts — replacement for 90093-MG3-000.
• 2x rear fairing hook bolts — replacement for 90117-MAT-000.
• 2x rear fairing / grab-rail hook bolts — replacement for 90116-MAT-000.
• 4x hook-bolt washers — replacement for 90514-MAT-000.
• 1x Biker Bling anti-seize compound pack (7 g).

Original Honda fixing references

Important fitment notes

• For Honda CBR1100XX Blackbird 1997–2007 with the original components at the listed positions.
• Check the original reference and fitting arrangement, especially with aftermarket screens, panels or modified components.
• Fairing panels, grab rail and exhaust components are not included. This rear kit does not include all of the motorcycle’s bodywork fixings.

When should you replace these fixings?

Inspect fixings when removing the relevant component. Replace missing hardware or damaged heads, threads, clips or rubber fittings with the correct type. New fixings cannot repair cracked panels, enlarged holes or damaged mounting threads.

Fitting information

Match each fixing to its intended position and start threaded fasteners by hand. Align the components before tightening; do not use a bolt to pull a misaligned panel into place. Follow Honda’s instructions and avoid overtightening plastic or rubber mountings. Use anti-seize only where the applicable procedure permits it. Check the fitted components are properly seated and secure.

For general background, read our guide to fitting motorcycle fairing bolts. Honda’s workshop procedure takes precedence.

Customer questions

Are hook bolts included in this rear kit?

Yes. The contents table lists two 90117-MAT-000 and two 90116-MAT-000 replacements, with four hook-bolt washers.